ELXR
SYS.ONLINE--:--:--
elxr / guides / gain-staging-ableton
// Guide · Max for Live

Gain staging in Ableton Live, the simple way

// Quick answer

Keep each track peaking well below 0 dB, around −12 to −6 dBFS, and leave the master peaking around −6 dBFS before mastering. Live won't clip inside, but many effects sound different depending on how hard you drive them, and the master will clip when you export.

Why levels still matter

Live mixes in 32-bit floating point, so a track meter in the red doesn't distort inside Live by itself. Levels still matter for three reasons: many effects (saturators, compressors, analog-style plugins) react to how hard you hit them, the master output and exported files do clip at 0 dBFS, and a mix where everything is loud leaves no room to make anything louder.

A simple routine

  1. Start with the clip. Set each clip's Gain so its peaks sit around −12 to −6 dBFS on the track meter, with the fader at 0 dB.
  2. Level before effects. Put a Utility first in a chain to set the level going into your effects, especially saturators and compressors.
  3. Match levels after effects. When an effect makes a sound louder, turn its output down so you judge the tone, not the volume.
  4. Mix with the faders. Once the inputs are sensible, do the balance with the faders.
  5. Leave master headroom. Keep the master peaking around −6 dBFS before mastering. Turn the whole mix down with a Utility on each group if needed, not the master fader.

Mistakes to avoid

  • Fixing it on the master. Turning the master down hides the problem; the effects on each track are still being driven too hard.
  • Louder = better. Always compare at matched levels.
  • Limiting while mixing. A limiter on the master makes everything seem fine until you take it off. Add it at the end.

Questions

Does Ableton clip if the track meter goes red?

Not inside Live, which uses 32-bit float. But the master output and exported fixed-point files clip at 0 dBFS, and effects can sound worse when driven hard.

What level should my master be before mastering?

Peaks around −6 dBFS is a common, safe target. It leaves room for mastering to work.

Should I gain stage MIDI instruments too?

Yes. Set the instrument's own output level so the track peaks in a sensible range before your effects.

ELXR Bundle
// Every ELXR device

ELXR Bundle

Every ELXR Max for Live device in one download. Drop any of them on a track and it works.